DC Powered Crane with Maximum Capacity 2,000 Lbs. at 4 Ft. Load radius
- Maximum Capacity 2,000 Lbs. at 4 Ft. Load radius
- Planetary Gear Winch with 2.7 HP Permanent Magnet Motor: 2,000 lb. single line capacity
- Includes ATB, needed when crane is used in construction as per 1926.1441(d)(2) & 1926.1416(d)(3)
- On / Off 12 Volt Electric Remote Pendant Control 18 Ft. (removable)
- Galvanized Aircraft Cable 1/4" x 62 Ft. w/ swivel hook (7,000 Lbs. Breaking Strength)
- Manual 360 Degree - Tapered Roller Bearings for ease of movement with a Manual Band Brake to control swing Boom Elevation - Full Power (-5 Deg. To 75 Deg.)
- Down haul pickle weight
- Boom Extension - Manual from 6 Ft. to 14 Ft.
- Overload Protection System
- Mounting plate is 15" square with a 12" square bolt pattern.
- Included: Battery Power Cable #1 x 25 Ft. with Quick Disconnect Mecon. Circuit Breaker, 150 Amp. Ground Cable 1/0 x 3 Ft. for the factory battery to the truck frame. Master Disconnect Switch and Bracket. Mounting Bolts Grade 8: 0.50" x 2.50" (Four). Terminal Lugs #1 GA 0.25 Dia. (2). Terminal Lugs #1 GA 0.37 Dia. (2). Crane-Truck Stability Plate . Recommended Installation Instructions. Owners Manual.
- Requirements: Consistent 12 Volt DC power source with sufficient amperage while crane is running under load. Installer responsible for meeting OSHA stability requirements of 29 CFR -1910.180 (c)(1). Boom Rest (P.N. 27860 for service body or P.N. 22158 for flat bed)
- Recommended: A dedicated battery, Group 31, deep cycle, near the crane is advised. 12K Outriggers for meeting vehicle stability requirements. Minimum Recommended Vehicle GVWR 9,000 lbs.
Write the First Review!