DC Powered Crane with Maximum Capacity 2,000 Lbs. at 3.25 Ft. Load radius
- Maximum Capacity 2,000 Lbs. at 3.25 Ft. Load radius
- Planetary Gear Winch with Permanent Magnet Motor
- Pedestal is eliminated, baseplate added for mounting on service body compartment top.
- On / Off 12 Volt Electric Remote Pendant Control 12 Ft. (removable)
- Galvanized Aircraft Cable 3/16" x 35 Ft. (4,200 Lbs. Breaking Strength)
- Travel Block w/ swivel hook for easy two part line hook up w/ swivel Hook
- Boom Elevation - Manual gas spring assist with five positions
- Boom telescopes manually from 5.5 Ft. to 9 Ft.
- Power Rotation - Unlimited with an electric motor
- Mounting plate is 12" square with a 9.5" square bolt pattern.
- NOTE : ANTI TWO-BLOCK NOT OFFERED ON THIS MODEL
- Included: Battery Power Cable #4 x 25 Ft. Circuit Breaker, 150 Amp. Ground Cable #4 x 3 Ft. for the factory battery to the truck frame. Master Disconnect Switch. Mounting Bolts Grade 8: 0.50" x 3.00" (Four). Recommended Installation Instructions. Owners Manual
- Requirements: Consistent 12 Volt DC power source with sufficient amperage while crane is running under load. Installer must assure the vehicle can maintain an appropriately level condition when the crane is in use under load. Boom Rest (P.N. 22167) or provision to prevent the crane from rotating when the vehicle is in motion
- Recommended: A dedicated battery, Group 31, deep cycle, near the crane is advised. Jackstand to provide stability and an appropriately level condition. Minimum Recommended Vehicle GVWR 8,600 lbs.
Write the First Review!